Das könnte Sie auch interessieren
Remote switch with relay for winches
€295.00*
For safety reasons, it is advisable to switch off the electric winch on the off-roader and only switch it on when needed. This is usually done with a disconnect switch in the engine compartment, so that awkward handling is necessary when you want to start the winch. With the switching relay and the switch supplied, this can be done conveniently from the driver's seat without having to lay the winch's power cables there. Only two thin wires are needed, the required switch is included in the delivery, the switching relay is mounted in the engine compartment. It has an additional switch directly on the relay housing and does not consume any power when it is not being switched. A recessed labelling field allows easy identification of the relay. The switch is a very high quality Carlingtech Contura switch (waterproof to IP67 standard), this fits seamlessly into our mounting frames or various consoles such as in the Land Rover Defender TD4 or other vehicles. The relay is designed for a continuous load of 500 A, please check if this is suitable for your winch. According to the manufacturer, a Warn 9.5XP requires 425 A, a Tabor 12K 457 A and the Warn 8274-50 450 A. Technical data:Maximum load capacity (continuous): 500 AMaximum load capacity (5 minutes): 700 AMaximum load capacity (1 minute): 1,100 AMaximum load capacity (10 seconds): 2,500 AVoltage: 10.1-16.5 VCurrent consumption in idle position: 0 mACurrent consumption during switching: less than 7 AConnections: 2x M10 screw boltsDimensions relay: 96x139x52 mmSwitch dimensions: 36x21 mm mounting holeSwitching capacity of the switch: max. 20 A
Product number:
NABS7700
Nakatanenga Cable Set for Winch Mounting in Land Rover Defender
€145.00*
Nakatanenga cable set winch mounting in Defender
In order to facilitate the installation of the winch in the Defender and to minimise sources of error, we have a complete cable set for this purpose mass-produced by a cable harness manufacturer. The cable lengths are adapted to the installation situation in the Land Rover Defender 90/110/130. Due to the cable cross-section of 50 mm², even high currents can be transmitted safely, so that enough current reaches the cable winch and is not converted into heat in the cable.
Delivery includes tubular cable lug M10 and battery pole clamp minus M10, for mounting on the vehicle's wiring.
Product number:
NASWB-CBL
Ähnliche Artikel
Cable winch Horntools Alpha 9.5 with 4.3 tons traction, 12 volt electric winch, with winch cable
From
€823.00*
Technical data of the rope winch Alpha 9.5
- Working range voltage: 10-16Volt- Max. Power consumption 365A **- Train speed free of load 7m / minute- traction 4300kg **- 3-stage planetary gear 230: 1 geared down- Gross weight: 40kg- Net weight: 32.3kg- Weight with steel cable and roller cable window: 37.5kg- Series wound motor *- Drum (ØxLength): 63x226mm- Overall size (LxWxH): 577 x 160 x 225mm* Series motor with an electrically generated magnetic field** Values can vary considerably, depending on the battery system, the winch can pull up to twice, the traction is designed for a standard 70AH battery. With more powerful battery systems, the pulling power must be limited by the current / voltage.The bundle consists of:1x horntools Alpha 9.5 electric winch with 4.3 tons traction1x Nakatanenga winch window1x winch hook1x winch rope (optionally in gray or orange)Please note that the depicted steel cable, the winch window and the winch hook from Superwinch are NOT included in the scope of delivery.
Product number:
HSW950012V-ORGM
Cable winch Horntools Alpha 12.0 with 5.4 tons traction, 12 volt electric winch, with winch cable
From
€1,473.00*
The Alpha 12.0 Super Speed Edition Technical data of the winch: - Working range voltage: 10-16Volt- Max. Power consumption 600A **- Train speed free of load 11m / minute- traction 5400kg **- 3-stage planetary gear 110: 1 geared down- Net weight: 25.8kg without rope and rope window- Series wound motor *- Drum (ØxLength): 63x226mm- Overall size (LxWxH): 577 x 160 x 225mm * Series motor with an electrically generated magnetic field ** Values can vary considerably, depending on the battery system, the winch can pull up to twice, the traction is designed for a standard 70AH battery. With more powerful battery systems, the pulling power must be limited by the current / voltage.The bundle consists of:1x horntools Alpha 12.0 electric winch with 5.4 tons traction1x Nakatanenga winch window1x winch hook1x winch rope (optionally in gray or orange)Please note that the depicted steel cable, the winch window and the winch hook from Superwinch are NOT included in the scope of delivery.
Product number:
HSW12000Q12V-ORGM
Horntools Alpha 9.5 winch, 4300kg traction, 12V
€549.00*
The Horntools Alpha 9.5
With its low weight and compact dimensions, it is perfect for vehicles with a total weight of up to 3.5 tons.
Especially for touring vehicles that are fully equipped, the winch should not have too much weight, but still have to do great things.
Furnishing:
9.2 mm Ø galvanized steel cable with 26 m length with hook
INFO: steel cable is included separately in the scope of delivery
stainless steel roller rope window
remote control 1x cable
potted reinforced relay (contactor) waterproof
motor IP67 sealed by groove with sealing ring
removable control unit (so that the control can be installed as desired)
freewheel lever * gear neutral position made of stainless steel
cross braces made of stainless steel
reinforced rope drum ** (suitable for use with plastic rope)
powder-coated aluminum die-cast housing, motor / gearbox
reinforced contactor housing made of deep-drawn sheet metal, powder-coated
internal drum brake with 3 brake shoes
cable length: 1.4 m
cable cross section: 35 mm²
3-year warranty - this warranty exists independently of the existing gratuitous statutory rights for defects. The statutory rights in respect of defects are not restricted by this guarantee.
Operating instructions
* A freewheel lever is used to decouple the gearbox to quickly unwind the winch by hand.
Technical specifications:
working range voltage: 10-16 Volt
max. Power consumption 365 Amp **
train speed free of load 7m / minute
traction 4,300 kg **
3-stage planetary gear 230: 1 geared down
gross weight: 40 kg
net weight: 32.3 kg
weight with steel cable and roller cable window: 37.5kg
Series wound motor *
drum (ØxLength): 63 x 226 mm
overall size (LxWxH): 577 x 160 x 225mm
* Series motor with an electrically generated magnetic field** Values can vary considerably, depending on the battery system, the winch can pull up to twice, the traction is designed for a standard 70AH battery. With more powerful battery systems, the pulling power must be limited by the current / voltage.
Product number:
HSW950012V
Nakatanenga Hidden Winch Mount Kit for Land Rover Defender
€1,839.00*
Prices incl. VAT; plus shipping costs / Parcel shipping
Available from stock - delivery time 1-3 working days
Product number:
NAHWMK-PB
Weight:
39.9 kg
For customers who need a winch on their Land Rover Defender but do not want the classic, martial look of a "normal" winch bumper we've developed the Hidden Winch Mount Kit. It is suitable for all Land Rover Defender 90/110/130 and allows an well hidden mounting of many common winches while maintaining a very "civil" look. In addition to the discreet appearance, the Nakatanenga Hidden Winch Mount Kit has many other product advantages:
- Improved slope angle of the vehicle by raised corners of the bumper
- Improved protection of the vehicle front by stable construction
- Protection of the rope against UV rays (important for plastic ropes!), rain and dust
- Improved theft protection due to hidden mounting location
- Suitable for vehicles with or without air conditioning (depending on the vehicle cutouts may be required on the grille)
- The freewheel of most winches is still accessible (you don't need a winch with an externally controllable freewheel)
- Integrated underrun protection (optionally aluminium natural or black powder-coated) to protect the steering linkage
- No repositioning of the license plate
We recommend the following winches for use with the Hidden Winch Mount Kit:
- Superwinch TigerShark 9.5SR
- Superwinch TigerShark 11.5SR
- Superwinch Rock 98
- Superwinch Rock 12.8
Among other winches, the following winches can not be used:
- Superwinch Talon
- Warn 8274
The bumper must be registered in the vehicle documents. This can be done by a fee-based individual acceptance.
- Depending on the vehicle version and winch type, it may be necessary to adapt the radiator grille.