Suspension lift kit TREKFINDER for JEEP® Renegade +30 millimetres the lift is approx. +30 millimetressuitable for the Renegade 4WD type BU model ‘TRAILHAWK’.A suitable version for the standard model of the Renegade 4WD Type BU can be purchased here.The standard shock absorbers can still be usedScope of delivery:  4x TREKFINDER coil spring 1x TREKFINDER sticker 1x piece parts certificate

Lifting spring kit TREKFINDER for JEEP® Renegade +30 millimetres     the ride height is approx. +30 millimetres     suitable for the standard model of the Renegade 4WD type BU.     A suitable version for the "TRAILHAWK" model can be purchased here.     the standard shock absorbers can still be used Scope of delivery:     4x piece TREKFINDER coil spring     1x piece TREKFINDER sticker     1x piece parts certificate

Wheel spacer TREKFINDER for JEEP® Wrangler JK +60 millimetres per axle ( 30 mm per disc/ side ) black anodised Suitable for the following models/ Wrangler models: Model Jeep Wrangler/ Jeep Wrangler Unlimited Type JK EG-TG-No. e4*2001/116*0116* Details: Made of high-strength aluminium alloy Black hard anodised with 60 mm wheel spacer per axle (30 mm per side) DRM system (washers with pressed-in bolts are slid over the existing vehicle studs and screwed tight) Use with steel rims is prohibited incl. fastening material (10 cone collar nuts) incl. TÜV® parts certificate Price and scope of delivery is for one axle The spacer rings may only be fitted in conjunction with standard LM wheels and in combination with the cone collar nuts supplied. The spacer rings are not permitted in conjunction with steel wheels. The screw-in length of all fastening elements must be at least 6.5 turns. Ensure that the stud bolts are of sufficient length. The notes in the assembly instructions for the spacer rings must be observed. The installation of spacer rings is not permitted if the diameter of the spacer rings is smaller than the diameter of the wheel contact surface. A modification approval by TÜV, DEKRA etc. is required. However, the entry in the vehicle documents can also only be made at the next appointment with the responsible registration authority. In the meantime, it is sufficient to carry the parts certificate and the confirmation of the modification approval. All fastening elements must be checked with a suitable torque spanner after approx. 100 km of driving. Compatibility or usability of specific snow chains cannot be guaranteed. PLEASE NOTE: Only in conjunction with LM wheels with corresponding GIESSTASCHEN = standard stud bolts or nut heads protruding beyond the wheel surface may sink.The standard stud bolts may have to be shortened.The minimum screw-in length of all fastening elements of 6.5 turns must be maintained.