Front Rubber Floor Mats Defender Td5
€89.00*
Floor mat / rubber mat for Land Rover Defender Td5, all models, scope of delivery: 2 pieces
Product number:
NA-STC50172
Headlight trim Land Rover Series III
From
€79.00*
Lamp ring / headlight trim
Land Rover Series III, available in various colours, price per piece.
Please select the desired colour below.
Product number:
NA345631-SM
13-pin E-Kit Universal, with AMC module, for Land Rover Defender up to and including MY98 and other vehicles
€120.00*
13-pin E-kit for Land Rover Defender up to and including MY98- also suitable for other vehicles.
A 13-pin e-kit offers the advantage over a classic 7-pin e-kit that it can be used to supply additional consumers. These can be rear fog lights or reversing lights as well as parking aids. The Jaeger plug-in system in particular has established itself as a permanent fixture on the market and has become indispensable for rear carriers and caravans. The advantages of a 13-pin E-kit are obvious and always justify the slightly higher purchase price compared to a 7-pin E-kit.
Including JAEGER AFC trailer control module for automatically increasing the flashing frequency.
Product number:
NA219712400006
7-pin E-Kit Universal, with AMC module, for Land Rover Defender up to and including MY98 and other vehicles
€79.00*
7-pin e-kit for Land Rover Defender up to and including MY98- also suitable for other vehicles.
Suitable for vehicles without Check Control and data bus system.
All parts required for installation are included in the scope of delivery. The installation does not need to be cleared by a specialist workshop!
Including JAEGER AFC trailer control module for adjusting the flashing frequency.
Product number:
NA219712400005
7-pin E-kit with multi-plug Defender Td5/Td4
€199.00*
fits all Defender from MY99 up to and including Td4
Product number:
NA-YWJ101500
A-pillar grab handle, for Land Rover Defender MY1987-2016, colour: silver or black
From
€67.00*
A-pillar grab handle
The easy-to-fit, stylish A-pillar grab handle makes it easier to get in and out of Defender.
The handles are made from anodised aluminium. Available in black or silver
Scope of delivery:
1 piece grab rail,
fixing material.
Product number:
DA8869M
Abenteuer4x4 - Recovery Eye Rear Crossbar Land Rover
€249.00*
Abenteuer4x4 - Recovery eye rear cross member Land Rover
The recovery eye / towing eye from Abenteuer 4x4 has a 360° rotatable shackle pin made of stainless steel. The basic construction made of aluminium and stainless steel is screwed to the original mountings of the rear cross bar of the Land Rover Defender. In addition, a step with pulled knobs is integrated for easy access to the roof rack.Scope of delivery: Spacer plate (10 mm aluminium, black powder-coated) Carrier plate 1 with step (3 mm stainless steel, black powder-coated) Carrier plate 2 (3 mm stainless steel, black powder-coated) 4 x 12 mm hexagon socket screw (stainless steel) 2 x 16 mm hexagon socket screw (stainless steel) Bow shackle with 13 ton breaking load
Product number:
BEOA4X46
Abenteuer4x4 - Rockslider - for Land Rover Defender
From
€1,239.00*
Abenteuer4x4 - Rockslider - for Land Rover Defender
The stainless steel Rockslider by Abenteuer 4x4 for the Land Rover Defender 90/110/130CC convince by a completely new design, low weight (approx. 12 kg/piece) and an easy mounting without drilling.To increase rigidity, two webs are welded on the back and the slotted holes on the long side are turned inwards.The Rocksliders not only serve to protect the bodywork, but also provide a secure foothold thanks to their non-slip surface made of drawn knobs, and their shape also protects against excessive dirt in the field. There are several openings on the underside for rinsing out dirt that has been picked up.The Rocksliders - made in Germany - are powder-coated black. Delivery includes fixing material.This item is bulky goods.Material: stainless steel, black powder coatedMaterial thickness: 3mm
Delivery:
1 set Rockslider stainless steel (left & right)Bracket and fixing materialSet of screws stainless steel
As a useful add-on, there are matching anti-slip pads for the Rockslider.You can find a suitable crossbar here.
Product number:
RSA4X4-90-PBM
Adaptor Plate for Brake- and Fog-Lights - Land Rover Defender previous to Model year 1998
€7.00*
Adaptor Plate for Brake- and Fog-Lights - Land Rover Defender previous to Model year 1998
This adaptor (1 piece) allows you to mount round breaklights and fog lights to older Defender models (previous to MY1998). This plate is compatible with your standard lights and our own LED lights.
Product number:
AMR3850
Air intake cover for all Land Rover Defender models, set of 3, powder coated alloy
From
€43.00*
Air intake cover
for all Land Rover Defender models (Tdi, Td5, Td4 2.4 and 2.2), set of 3, made of 2 mm aluminium to replace the plastic covers. Powder coated, comes with stainless steel fittings.
Image similar
Product number:
LE-KF3-AL-QSM
Air scoop for Land Rover Defender
From
€25.00*
Air scoop, for Land Rover Defender 90/110/130
right or left side, for adhesive, rivet or screw mounting.
Material: steel, black
Product number:
NADEFAI-LHM
Anhängerkupplung Discovery II
€696.00*
Trailer coupling for Landrover Discovery II incl. E-kit, E-approved and ball head.
Product number:
AHKDII
Anti-slip pads for CargoBear
From
€14.00*
Self-adhesive anti-slip pads
Perforated metal sheets, as used on our CargoBear roof racks, on ladders, steps and other climbing aids on vehicles, are much safer than regular metal surfaces. Additional anti-slip pads, however, offer an unbeatable safety advantage, especially in wet or dirty conditions. The anti-slip pads are designed to perfectly match the hole patterns and due to its black color, they also compliment the overall look of our products. The material for the pads originates in the sports sector and has been widely used on skateboards, for example.
For the CargoBear, we offer ready-cut, self-adhesive anti-slip pads measuring 16 x 24 cm individually or in sets of 3, 6 or 12. Please note: the multi-packs provide increasing savings regarding the price per item.
Since the pads are manufactured with in-house laser cutting technology, we can supply custom formats on request.
Product number:
ARS-CGBM
Anti-theft nut set for winch and front bumper
From
€29.00*
Safety nut set - optionally M10, M8 or M6
1 Set of Security Nuts & WrenchesSecure your valuable accessories firmly to your Land Rover with these tamper proof nuts.
Ideal for securing your winch and front bumper.
Each set contains 4 nuts and 1 key.
Product number:
MWFS-M10M
Armrest for Land Rover Defender 90/110/130
From
€69.00*
Our armrest for the doors of your Land Rover Defender 90/110/130 is just that bit of extra that adds a whole new level of comfort - even on long journeys. Finally you can rest your elbow comfortably, making driving so much more relaxing and safe.
Our armrest is made of an intricate aluminium subframe which is covered by hand in naturally tanned leather (black). The rest is available either for left or right hand side doors or, with a saving, as a bundle for both doors. No drilling required.
Please choose.
Product number:
NATPDEF-L-BLKM
Assembly flat rate Scheelmann sports seat
From
€75.00*
Installation flat rate for Scheelmann seats, with or without seat heating, for Land Rover Defender with or without pre-equipped seat heating.
Price for 1 seat.
The installation effort differs significantly depending on whether the seat to be installed has seat heating or not and whether seats with seat heating were already installed in the vehicle. Please select the applicable variant.
Please note: The price refers to the installation fee only, the product to be installed must be purchased separately.
When ordering, please include your telephone number for the necessary appointment. The assembly is only possible on site in Berg bei Neumarkt (postal code: 92348).
Product number:
MONSCHEEL-HSOSM
Bearlight stainless headlight rims for 7" Land Rover Defender main lights
From
€30.00*
Our specially made stainless steel headlight bezels once and for all end the dreaded rust problem of the original Defender mounting rims. Suitable for all halogen, clear glass, and LED main Defender headlights by producers like J.W.Speaker, BMAC, Hella, Nolden, Vision-X, Truck-Lite, Wipac, or Sirius. Price is for one pair.
Also available in black powder coated - a perfect mix of understatement and technical state of the art! If you work on your lights, why not get the stainless fitting equipment, too.
Product number:
BLERDEF-VAM
Black Heritage Headlight plates (with inlet gills) in aluminium, powder coated
From
€249.00*
Matching to our black Heritage grille:Black headlight plates with inlet gills and silver OR black powder coated headlight rings.The plates are manufactured EXCLUSIVELY for us and UNIQUE in their looks!
Material: high-strength aluminium, black powder coated
1 pair plates with headlight rings and stainless steel mounting kit for every Land Rover Defender 90, 110 or 130.
Product number:
SUHTALK-B-SM
Black Heritage Headlight plates in aluminium, powder coated
From
€249.00*
Matching to our black Heritage grille:
Black headlight plates with inlets and silver OR black powder coated headlight rings.The plates are manufactured EXCLUSIVELY for us and UNIQUE in their looks!
Material: high-strength aluminium, black powder coated
1 pair plates with headlight rings and stainless steel mounting kit for every Land Rover Defender 90, 110 or 130.
Product number:
SUHTAL-B-SM
Black Mesh" upholstery set for Land Rover Defender TD5
€198.00*
Black Mesh" upholstery kit for Land Rover Defender
Included in delivery are all foam moulded parts, covers for seat and headrest, required fixing material and upholstery spray adhesive.
Suitable for all front seats up to 2007 for Land Rover Defender TD5 (NOT suitable for TD4!!)
Product number:
RTRBLKMESH
Bonnet Hinges Defender, anti-theft
From
€69.00*
Nakatanenga bonnet hinges for Land Rover Defender (all models, all model years) address two problems associated with the original hinges: for one they are more durable and have no play, additionally they greatly complicate bonnet theft.
We have put emphasis on ease of fitting - this can be done by yourself. There are no holes that need drilling as only existing ones are used, all fixings, icluding the special safety-socket are supplied.
The hinges are available in stainless steel or with black powder coating, please choose the desired finish.
Product number:
NAMHSDEF-VAM
Bulkhead for Land Rover Defender, material: Stainless steel
From
€2,955.00*
The bulkhead is pretty much the most complex body part in a Landy – and one of the most vulnerable components, too. For one, it’s sporting many edges, corners, folds, curves and rivet connections and requires a considerable number of screw holes: to the frame, to the connections in the engine bay and to the windshield. Add to that a whole bunch of openings for steering, pedals, air and electrics and you see the problem.
All this structural complexity combined with its positioning exposes the bulkhead to water splashing up from below or trickling down from above. Dirt and chemicals collect in the nooks and crannies and trap moisture almost permanently. On the inside of the cabin condensation or leaks can produce the same effect behind the dashboard, panels or floor mats, thereby creating constant moisture exposure from both sides. No wonder, that the bulkhead is one of those components that suffer most from visible or hidden corrosion. Over time, it can even affect the frame.
In case you are tired of piecemeal patch jobs on your Td5’s or 300Tdi’s rusty bulkheads or you are contemplating a proper restauration anyway, we can offer you a complete, primer-coated high-quality bulkhead, made in the EU.Material: Stainless steel
Product number:
SPRITZWAND-TD5M
Bulkhead Removal Bar for Land Rover Defender 90ST / 110HT
€199.00*
Conversion Kit for Bulkhead removal in Defender 90STs and 110HTs. Allowing you to tilt the seats further, thanks to the larger cut-out.
Up to MY 2007
Product number:
BHRB-DE
Cargo Netz Expedition für Land Rover Defender 90, 110
From
€139.00*
Cargo Network Expedition for Land Rover Defender 90, 110 Versatile, handmade, heavy duty - proven Air Cargo technology for the Defender! Anyone who has tried our Cargo Network Expedition once in the Landy, will never again consider anything else, especially nothing from the hardware store. Made of highly durable and UV-resistant 25mm webbing, hand stitched with tear-resistant special yarn. This keeps every load under control: more safety and comfort for the driver and passengers. Thus, the Cargo Network Expedition functions equally as a luggage net at the top of the hardtop, as a separation net behind the front seats or as a securing net for the cargo. Dimensions: about 118x80 cm Ideal for fastening are our belt staple. MADE IN EU Delivery:1x cargon net14x belt staples28x fastening rivets Our Mesh Cargo Net for the Land Rover Defender can be found here.
Product number:
NACNEDEF-BLKM